It may appear that hanging a picture is a simple task. But sometimes, a hammer and a nail aren’t enough. It’s probably better to hang objects from a stud, but this isn’t always possible. For example, Molly bolts and toggle bolts can make hanging goods easier. They can also protect your walls from damage. Continue reading to find out how to utilize molly bolts.
Molly bolt can get used to secure heavy things against hollow walls. They usually have a pointed end to help insert the bolt, the bolt or nut itself, and the anchor. The anchor is a threaded sleeve that wraps around the bolt and stretches as the bolt is tightened. Molly bolts are almost always utilized in residential applications for drywall, although they can also get used for other materials like sheet metal.
Give this article a careful read to know the complete procedure of using a molly bolt:
Drill a pilot hole in the area where the molly bolt will get inserted. However, most molly bolts have a conical tip that can get driven in without a pilot hole. The hole on the molly bolt should be less than the width of the sleeve.
Insert the molly bolt’s tip into the hole and hammer it in place. If the hole gets made to the correct size, gentle taps should suffice, but more power will be required if it is too tiny. Drive it in until the sleeve’s collar is flush against the wall.
The molly bolt will be over-tightened if you use a drill with a screwdriver tip or other high torque equipment. Tighten the bolt until it resists hand tightening, and the anchor seems snug.
Just loosen the bolt sufficiently to fit the thing you’ll hang from it. It is usually limited to one or almost two complete turns.
The thing should get hung from the bolt. Most mirrors and picture frames have a wire or hook that you can use to connect to the molly bolt.
Key Things You Need To Know:
Molly bolts with a pointed tip are ideal for mounting items on walls. Molly bolts with a flat point perform nicely on plaster walls. Molly bolts are also available in sizes suitable with hollow doors. Molly bolts of the largest size can support up to 50 pounds. Molly bolts, unlike toggle bolts, can be withdrawn from the wall and reused. They are notoriously difficult to remove.
Rather than removing them, you can tap them into the wall with a screwdriver until they have been hidden beneath the surface. Then fill in the hole with spackle and paint. Toggle bolts are not reusable. The screw can get taken out of the wall. However, the toggle will fall out, and you will most likely lose it.
In the end, we can say that molly bolts are categorized according to their weight. Make sure you’re using the right molly bolt for the job. Consider acquiring a molly driver if you use a lot of molly bolts daily. Without changing tools, you can drive and set a molly bolt using this tool.